A light tapping at rear of trigger guard with a plastic hammer may be necessary because inletting of stock to guard is often very tight. This disassembly is sufficient for cleaning the rifleĢ To remove or replace stock, unscrew upper tang screw (18) and remove it from rifle. Grasp stock and action assembly and barrel-receiver group firmly, and pull them apart. Takedown of the Model 62A is accom-■ plished by unscrewing the assembly screw (40) and pulling it out until it clears the corresponding hole on the right rear of the receiver (1). 22 short, long, and long-rifle cartridges interchangeably. 22 short gallery model or standard model handling. The Model 62A is optionally offered in a. In 1949 the forearm was again changed, to a semi-beavertail type. The actual designation of the rifle as Model 62A occurred in 1939 when the forearm was changed from 6" to SVs" in length, and the number of circular grooves on it from 10 to 17.
Tem was authorized to that formerly used in the Model 1890 wherein initial movement of the slide handle starts opening movement of the bolt. Wessel of Whippany, N.J., is a technical illustrator long interested in firearms. On May 12, 1938, a change in the locking sys. In the original Model 62 the locking system was so designed that the slide handle moved approximately Va" to the rear before opening movement of the bolt commenced. In 1932 the Model 1890 was superseded by the Model 62. The Winchester Model 62A cal.22 tubular magazine rimfire rifle is a development of the Winchester Model 1890 introduced in that year. Removal of ejector stop (ISA) is accomplished by drifting out from rear of guard toward front. This will disengage plunger (26A) from detent slot in lock.ĭrift lock out of guard to left, remove plunger (26A) and spring (25A) from hole inside lock hole. Place a small drift or other suitable tool in small hole in lock visible through top of guard and turn lock clockwise (viewed from right side of guard) by moving drift forward. Place trigger lock (24A) in "off" position. Hammer catch (22A) may now be lifted out of guard. Drift out trigger pin (19A) and remove trigger (20A) and spring (21A) upward out of guard. Drift out hammer spring abutment (17A) from left to right.
Remove hammer (13A) with carrier (10A), and hammer spring (15A) and guide rod (14A) intact. Remove carrier stop screw (7A).ĭrift out carrier spring pin (8A) and lift carrier upward to allow removal of carrier spring (9A). Lift action slide lock upward and out of guard. Remove action slide lock spring (6A) from hole in lower edge of action slide lock (4A). Drift out action slide lock pivot (5A) from right to left. Drift out takedown screw stop pin (3A) and remove takedown screw (2A) from guard (1A).
0 kommentar(er)
